3.1 Getting Started
Make sure that you have completed the basic system installations in Chapter 2, then follow these steps to start up the server.
Connect a Monitor
Connect a monitor by plugging hte monitor cable to the video port (blue port) on the server rear panel.
Video Port
Connect the Power Cord
1.Adjust the voltage selector to the correct voltage in your area.
2.Connect a power cord to the power connector on the rear panel.
3.Plug the power cord to a grounded
wall socket. | Power | Voltage |
| Connector | Selector |
Power On
Turn on the server by pressing the power switch on the front panel.
Power Switch
Check Power Status
After turning on the power, the power LED lights up. If it doesn’t, check the power connection.
Power LED
32 | Chapter 3: Powering Up |