5.Follow steps 1 to 4 to install the other rail.

6.Insert the rails to the holes on the front panel and match the 68-pin connector at the rear of the combo box with the connector on the front panel.

7.Firmly push the combo box into the chassis until it fits in place.

In case you need to replace either the CD-ROM or the floppy drive inside the combo box, follow these steps.

1.Use a Philips (cross) screwdriver to remove the screws the secure the drives to the combo box.

2.To remove the CD-ROM drive, insert the end of the screwdriver into the upper hole on the side of the combo box and lightly push the drive toward the front. The drive slips out for about an inch. Pull the drive out of the combo box.

3.To remove the floppy drive, insert the end of the screwdriver into the lower hole on the side of the combo box and lightly push the drive toward the front. When the drive slips out, pull it out.

34

Chapter 2: Hardware Setup