Asus B85M-G, B85MG 1.8Onboard LEDs, B85M-GOnboard LED, 1.Standby Power LED, B85M-GChassis intrusion connector, 13.Chassis intrusion connector (4-1pin CHASSIS)

13.Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

B85M-G

CHASSIS

+5VSB MB Chassis Signal GND

B85M-G Chassis intrusion connector1.8Onboard LEDs1.Standby Power LED

The motherboard comes with a standby power LED that lights up to indicate that the system is ON, in sleep mode, or in soft-off mode. This is a reminder that you should shut down the system and unplug the power cable before removing or plugging in any motherboard component. The illustration below shows the location of the onboard LED.

SB_PWR

B85M-G

ON OFF

Standby Power Powered Off

B85M-G Onboard LED

1-20 Chapter 1: Product introduction