Manuals / Brands / Computer Equipment / Computer Hardware / Asus / Computer Equipment / Computer Hardware

Asus CUSI-FX 11)Floppy Disk Drive Connector (34-1pinFLOPPY), 10)Primary (Blue) / Secondary IDE Connectors (Two 40-1pinIDE)

1 112

Download 112 pages, 4.27 Mb

.3

3.HARDWARE SETUP

10)Primary (Blue) / Secondary IDE Connectors (Two 40-1pin IDE)

These connectors support the provided UltraDMA/66 IDE hard disk ribbon cable. Connect the cable’s blue connector to the motherboard’s primary (recommended) or secondary IDE connector, and then connect the gray connector to your UltraDMA/66 slave device (hard disk drive) and the black connector to your UltraDMA/66 master device. It is recommended that non-UltraDMA/66 devices be connected to the secondary IDE connector. If you install two hard disks, you must configure the second drive to Slave mode by setting its jumper accord- ingly. Please refer to your hard disk documentation for the jumper settings. BIOS now supports specific device bootup (see 4.4.1 Advanced CMOS Setup). (Pin 20 is removed to prevent inserting in the wrong orientation when using ribbon cables with pin 20 plugged).

TIP: You may configure two hard disks to be both Masters with two ribbon cables – one for the primary IDE connector and another for the secondary IDE connector. You may install one operating system on an IDE drive and another on a SCSI drive and select the boot disk through 4.4.1 Advanced CMOS Setup.

IMPORTANT: UltraDMA/66 IDE devices must use a 40-pin 80-conductor IDE cable for 66MBytes/s transfer rates.

H/WConnectors

SETUP

CUSI-FX

CUSI-FX IDE Connectors

Primary IDE Connector							Secondary IDE Connector





		PIN 1

NOTE: Orient the red markings on the IDE ribbon cable to PIN 1

11)Floppy Disk Drive Connector (34-1pin FLOPPY)

This connector supports the provided floppy drive ribbon cable. After connect- ing the single end to the board, connect the two plugs on the other end to the floppy drives. (Pin 5 is removed to prevent inserting in the wrong orienta- tion when using ribbon cables with pin 5 plugged).

NOTE: Orient the red markings on the floppy ribbon cable to PIN 1.

CUSI-FX

PIN 1

CUSI-FX Floppy Disk Drive Connector

30	ASUS CUSI-FX User’s Manual

Contents

Page ASUS CUSI-FX 1.02 E570 August ASUS CUSI-FXUser’s Manual ASUSTeK COMPUTER INC. (Asia-Pacific) ASUS COMPUTER INTERNATIONAL (America) ASUS COMPUTER GmbH (Europe) Page Page Page 1.1How This Manual Is Organized 1.2 Item Checklist 2.1The ASUS CUSI-FX 2.1.1 Specifications 2.1.2 Specifications–OptionalComponents 2.1.3Performance 2.1.4Intelligence 2.2CUSI-FXMotherboard Components Page 3.1CUSI-FXMotherboard Layout 3.2Layout Contents 3.3Hardware Setup Procedure 3.4Motherboard Settings 2)USB Device Wake Up (USBPWR0, USBPWR1) NOTES: 4.5.1Power Up Control Setting USBPWR0/USBPWR1 3)CPU External Frequency Setting (JP3, JP1, JP2, JP0) Manual CPU Settings Frequency Selection Switches WARNING 3.5System Memory (DIMM) 3.5.1 General DIMM Notes 3.5.2DIMM Memory Installation 3.6Central Processing Unit (CPU) 3.7Expansion Cards 3.7.1 Expansion Card Installation Procedure 3.7.2 Assigning IRQs for Expansion Cards H/W Standard Interrupt Assignments IRQ Standard Function Interrupt Request Table for this Motherboard 3.7.3Audio Modem Riser (AMR) Slot 3.8Connectors 3)Fast-EthernetPort Connector (RJ45) LED1 LED2 H/WSETUP 5)Parallel Port Connector (Burgundy 25-pinPRINTER) 6)Serial Port Connectors (Teal/Turquoise 9-pinCOM1) Onboard Serial Port 4.2.2 I/O Device Con- figuration 7)Monitor Output Connector (Blue 15-pinVGA1) 8)Game/MIDI Connector (Gold 15-pinGAME_AUDIO) (optional) 9)Audio Port Connectors (Three 1/8” GAME_AUDIO) (optional) 10)Primary (Blue) / Secondary IDE Connectors (Two 40-1pinIDE) 11)Floppy Disk Drive Connector (34-1pinFLOPPY) 12)IDE Activity LED (2-pinPLED) Power Supply (PWR_FAN), CPU (CPU_FAN), Chassis (CH_FAN) Fan Connectors (3 pins) do not place jumper caps over these pins 14)Wake-On-RingConnector (2-pinWOR) Wake On LAN or PCI Modem 4.5.1 Power Up Control 15)Wake-On-LANConnector (3-pinWOL_CON) Wake-On-Lan 16)USB Headers (10-1pin USB1, 5-1pin USB2) 17)Internal Audio Connectors (4-pinCD1, AUX, MODEM) (on audio model only) 18)ASUS iPanel Connector (12-1pin AFPANEL) 19)ASUS iPanel Audio Connector (12-1pin AAPANEL) (on audio model only) CUSI-FXSystem Panel Connectors 20)System Warning Speaker Connector (4-pinSPEAKER) 21)Keyboard Lock Switch Lead (2-pinKLOCK) 22)System Power LED Lead (3-1pin PWRLED) 23)System Message LED Lead (2-pinMSG.LED) 24)System Management Interrupt Lead (2-pinSMI) 27)ATX Power Supply Connector (20-pinblock ATXPWR) 28)Power Supply Thermal Sensor Connector (2-pinPWRTMP) 3.9Starting Up the First Time Award BIOS Beep Codes 4. BIOS SETUP Powering Off your computer: Shut Down Shut down the computer 4.1Managing and Updating Your BIOS 4.1.1 Upon First Use of the Computer System 4.1.2 Updating BIOS Procedures Page Page 4.2BIOS Setup Program 4.2.1BIOS Menu Bar 4.2.2 Legend Bar General Help Saving Changes and Exiting the Setup Program Scroll Bar Sub-Menu 4.3Main Menu 4.3.1Primary & Secondary Master/Slave [User Type HDD] Translation Method [LBA] Cylinders Translation Method Head Sector CHS Capacity Maximum LBA Capacity Multi-SectorTransfers [Maximum] 4.3.2 Keyboard Features Language [English] Supervisor Password [Disabled] / User Password [Disabled] A Note about Passwords Forgot the Password Halt On [All Errors] 4.4Advanced Menu CPU Level 2 Cache ECC Check [Disabled] Processor Serial Number [Disabled] BIOS Update [Enabled] PS/2 Mouse Function Control [Auto] USB Legacy Support [Auto] Notes for JumperFree Mode 4.4.1Chip Configuration Refresh RAS Assertion [5T] Refresh Queue Depth [12] SDRAM Refresh Mode [Staggered 1T] Memory Hole At Address [None] Video Memory Cache Mode [USWC] USB Function [Enabled] Onboard LAN [Enabled] Onboard LAN Boot ROM [Disabled] Onboard PCI Audio Controller [Enabled] 4.4.2I/O Device Configuration UART2 Use Infrared [Disabled] Onboard Parallel Port [378H/IRQ7] Parallel Port Mode ECP DMA Select Parallel Port Mode [ECP+EPP] 4.4.3PCI Configuration PCI IRQ Resource Exclusion 4.4.4Shadow Configuration 4.5Power Menu Video Off Option [Suspend ->Off ] Video Off Method [DPMS OFF] HDD Power Down [Disabled] Suspend Mode [Disabled] PWR Button < 4 Secs [Soft Off] 4.5.1Power Up Control Power Up By Keyboard [Disabled] Power Up By USB [Disabled] 2) USB Device Wakeup 3.4 Motherboard Settings Automatic Power Up [Disabled] 4.5.2Hardware Monitor 4.6Boot Menu Boot Sequence Plug & Play O/S [No] Boot Virus Detection [Enabled] Quick Power On Self Test [Enabled] Boot Up Floppy Seek [Enabled] Full Screen Logo [Enabled] 4.7Exit Menu Exit Saving Changes Exit Discarding Changes Load Setup Defaults Discard Changes Save Changes Page 5.1Install Operating System 5.2 Start Windows 5.3CUSI-FXMotherboard Support CD 5.3.1 Installation Menu ReadMe: Exit: 5.4Display Driver 5.5Lan Driver 5.6ASUS PC Probe 5.7Install ASUS Update 5.8YAMAHA SoftSynthesizer S-YXG50 5.9PC-Cillin98 5.10Adobe Acrobat Reader 5.11Cyberlink Video and Audio Applications 5.11.1 System Requirements 5.11.2 Cyberlink Contact Information 5.11.3Installation Procedures 5.12Uninstalling Programs Page 6.1Display Properties Properties Settings Advanced Display Modes Video Setting 3D Setting Color Color D3D D3D OpenGL OpenGL 6.2ASUS PC Probe 6.2.1 Starting ASUS PC Probe 6.2.2Using ASUS PC Probe CPU Cooling System Setup History Information Hard Drives Memory Device Summary DMI Explorer Utility Execute Program 6.2.3ASUS PC Probe Task Bar Icon 6.3ASUS Update 6.4Yamaha XGPlayer 6.4.1 Using Yamaha XGPlayer 6.4.2 Yamaha XGstudio Player Control Panel 6.4.3 Yamaha XGstudio Mixer Control Panel 6.5CyberLink PowerPlayer SE 6.5.1 Starting CyberLink PowerPlayer SE 6.5.2 CyberLink PowerPlayer Control Panel 6.6CyberLink PowerDVD 6.6.1 Starting CyberLink PowerDVD 6.6.2 CyberLink PowerDVD User Interface 6.7CyberLink VideoLive Mail 6.7.1Starting VideoLive Mail 6.7.2 CyberLink VideoLive Mail User Interface Page 7.1 Glossary APPENDIX Boot Bus Master IDE Byte (Binary Term) COM Port LPT Port (Line Printer Port) MMX OnNow PC100 PCI Bus (Peripheral Component Interconnect Local Bus) ROM (Read Only Memory) SCSI (Small Computer System Interface) SDRAM (Synchronous DRAM) SPD for SDRAM module SSE (Streaming SIMD Extensions)