5.4.2Silicon Image RAID configurations

The Silicon Image RAID controller supports RAID 0 and RAID 1 configurations. Use the Silicon Image RAID utility to configure a disk array.

Installing External Serial ATA (E-SATA) hard disks

To install the External SATA hard disks for a RAID configuration:

1.Connect one end of the E-SATA signal cables to the rear panel port.

2.Connect the other end of the E-SATA signal cables to the external SATA disk drives.

The installation procedure in this section is provided for reference only, refer to the user’s manual that comes with the external drive for detailed installation instructions.

Setting the BIOS RAID items

After installing the hard disk drives, make sure to set the necessary RAID items in the BIOS before setting your RAID configuration.

To set the BIOS RAID items:

1.Boot the system and press <Del> during the Power-On Self-Test (POST) to enter the BIOS Setup Utility.

2.From the Advanced > Onboard Device Configuration menu item in the BIOS set the Silicon SATA II Controller item to RAID Mode. See section “4.5.4

Onboard Device Configuration” for details.

3.Save your changes and Exit Setup.

Launching the Silicon Image Array Management Software

Launch the Silicon Image Array Management software from Windows® XP by clicking the Start button and selecting All Programs > Silicon Image > Sam

For details on the Silicon Image SATARaid™ RAID configuration, refer to the “Sil3132 SATA RAID User’s Manual” in your motherboard support DVD.

5-32

Chapter 5: Software support