2.8.4Installing Fusion Block System accessory
Install your watercooling system to the motherboard using the bundled accessories to obtain the best thermal solution.
Package contents
|
|
3/8” ID tubes x 2 | 1/2” to 3/8” ID fittings x 2 10mm to 3/8” ID fittings x 2 |
1/2” ID tube clips x 2 | 3/8” ID tube clips x 6 |
For watercooling system with 3/8” ID tubes
1.Firmly press a tube clip and fit the tube into the clip.
2.Press the clip and connect the tube to the waterblock. When done, release the clip to tighten the two together.
3.Repeat Step 1 and 2 for another tube. Make sure that both tubes are well connected to prevent leak, and then fill the coolant into the reservoir.
1 | 2 |
ROG Maximus Formula (Special Edition) / Maximus Formula |