4-164-16
4-164-16
4-16 Chapter 4: BIOS setupChapter 4: BIOS setup
Chapter 4: BIOS setupChapter 4: BIOS setup
Chapter 4: BIOS setup
4.3.64.3.64.3.64.3.64.3.6 Primary IDE MasterPrimary IDE MasterPrimary IDE MasterPrimary IDE MasterPrimary IDE Master
The BIOS automatically detects the values opposite the dimmed items
(Capacity, Cylinder, Head, Precomp, Landing Zone, Sector, and Transfer
Mode, and S.M.A.R.T Status). These values are not user-configurable. These
items show 0 or None if no IDE device is installed in the system.

PIO ModePIO Mode

PIO ModePIO Mode

PIO Mode

Sets the PIO mode for the IDE device. The settings Mode 0 to 4 allow
successive increase in performance. Configuration options: [Auto] [Mode 0]
[Mode 1] [Mode 2] [Mode 3] [Mode 4]

UDMA ModeUDMA Mode

UDMA ModeUDMA Mode

UDMA Mode

When this item is set to [Auto], the UDMA capability allows improved
transfer speeds and data integrity for supported IDE devices. Configuration
options: [Disabled] [Auto]

Primary IDE Master [Auto]Primary IDE Master [Auto]

Primary IDE Master [Auto]Primary IDE Master [Auto]

Primary IDE Master [Auto]

Select [Auto] to automatically detect an IDE hard disk drive. If automatic
detection is successful, the BIOS automatically fills in the correct values for
the remaining fields on this sub-menu. If the hard disk was already
formatted on a previous system, the BIOS may detect incorrect
parameters. Select [Manual] to manually enter the IDE hard disk drive
parameters. Refer to the next section Manually detecting an IDE drive. If
no drive is installed select [None]. Configuration options: [None] [Auto]
[Manual]
While entering Setup, the BIOS automatically detects the presence of
IDE devices. There is a separate sub-menu for each IDE device. Select a
device item then press <Enter> to display the IDE device information.
F1:Help ↑↓ ↑↓
↑↓ ↑↓
↑↓ : Select Item -/+: Change Value F5: Setup Defaults
ESC: Exit →← →←
→← →←
→←: Select Menu Enter: Select Sub-menu F10: Save and Exit
Phoenix-Award BIOS CMOS Setup Utility
Main
Select Menu
Item Specific Help
Set a PIO mode for the
IDE device. Mode0 through
4 successive increase in
performance.
Primary IDE Master
PIO Mode [Auto]
UDMA Mode [Auto]
Primary IDE Master [Auto]
Access Mode [Auto]
Capacity 0 MB
Cylinder 0
Head 0
Precomp 0
Landing Zone 0
Sector 0
Transfer Mode None
S.M.A.R.T Status None