8.USB 2.0 ports 3 and 4. These two 4-pin Universal Serial Bus (USB) ports are available for connecting USB 2.0 devices.

9.USB 2.0 ports 1 and 2. These two 4-pin Universal Serial Bus (USB) ports are available for connecting USB 2.0 devices.

10.Serial connector. This 9-pin COM1 port is for serial devices.

11.S/PDIF out jack. This jack connects to external audio output devices.

12.PS/2 keyboard port. This purple connector is for a PS/2 keyboard.

2.7.2 Internal connectors

1.IDE connectors (40-1 pin PRI_IDE, SEC_IDE)

This connector supports the provided UltraDMA IDE hard disk ribbon cable. Connect the cable’s blue connector to the primary (recommended) or secondary IDE connector, then connect the gray connector to the UltraDMA slave device (hard disk drive) and the black connector to the UltraDMA master device.

• Follow the hard disk drive documentation when setting the device in master or slave mode.

•Pin 20 on each IDE connector is removed to match the covered hole on the UltraDMA cable connector. This prevents incorrect orientation when you connect the cables.

•The hole near the blue connector on the UltraDMA cable is intentional.

PRIIDE

PIN 1

SECIDE

K8V

 

 

K8V SE Deluxe IDE Connectors

 

PIN 1

NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1.

2-22

Chapter 2: Hardware information