9.Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

M2N32 WS PRO

+5VSB_MB Chassis Signal GND

CHASSIS

(Default)

M2N32 WS PRO Chassis intrusion connector

10.ATX power connectors

(24-pin EATXPWR, 8-pin EATX12V)

These connectors are for ATX power supply plugs. The power supply plugs are designed to fit these connectors in only one orientation. Find the proper orientation and push down firmly until the connectors completely fit.

ATX12V

+12V DC

+12V DC +12V DC

+12V DC

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

GND GND GND GND

M2N32 WS PRO

M2N32 WS PRO ATX power connectors

EATXPWR

+3 Volts Ground

+12 Volts +5 Volts

+12 Volts +5 Volts

+5V Standby +5 Volts

Power OK -5 Volts

Ground Ground

+5 Volts Ground

Ground Ground

+5 Volts PSON#

Ground Ground

+3 Volts -12 Volts

+3 Volts +3 Volts

ASUS M2N32 WS Professional

2-35