These connectors are for USB 2.0 ports. Connect the USB module cable to any of these connectors, then install the module to a slot opening at the back of the system chassis. These USB connectors comply with USB 2.0 specification that supports up to
480Mbps connection speed.
|
| USB78 |
| USB910 | ||
|
| USB+5V USB P8- USB P8+ | GND NC |
| USB+5V USB P10- USB P10+ | GND NC |
| PIN 1 | USB+5V USBP7- P7+USB | GND | PIN 1 | USB+5V USBP9- P9+USB | GND |
|
|
USB1112
|
| USB+5V USB_P12- USB_P12+ | GND NC | ||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
PIN 1 | USB+5V USB P11- USB P11+ | GND | |||||
|
|
PI
Never connect a 1394 cable to the USB connectors. Doing so will damage the motherboard!
The USB 2.0 module is purchased separately.
7.Digital audio connectorThis connector is for an additional Sony/Philips Digital Interface (S/PDIF) port.
+5V | SPDIFOUT GND |
SPDIF_OUT
Ensure that the audio device of Sound playback is VIA High Definition Audio (the name may be different based on the OS). Go to Start > Control Panel > Sounds and Audio Devices > Sound Playback to configure the setting.
The S/PDIF module is purchased separately.
Chapter 1: Product introduction |