Memory configurations

You may install 1GB, 2GB, 4GB, 8GB, and 16GB unbuffered ECC and non‑ECC DDR3 DIMMs into the DIMM sockets.

• You may install varying memory sizes in Channel A and Channel B. The system maps the total size of the lower-sized channel for the dual-channel configuration. Any excess memory from the higher-sized channel is then mapped for single-channel operation.

•Always install DIMMs with the same CAS latency. For optimal compatibility, we recommend that you install memory modules of the same version or date code (D/C) from the same vendor. Check with the retailer to get the correct memory modules.

•Memory module with memory frequency higher than 2133MHz and its corresponding timing or the loaded DRAM OC profile is not the JEDEC memory standard. The stability and compatibility of the memory modules depend on the CPU’s capabilities and other installed devices.

•Due to the CPU spec., AMD AM3 100 series CPUs support up to DDR3 1066MHz. With ASUS design, this motherboard can support up to DDR3 1333MHz.

•When overclocking, some AMD CPU models may not support DDR3 1600 or higher frequency DIMMs.

•Due to the memory address limitation on 32-bit Windows OS, when you install 4GB or more memory on the motherboard, the actual usable memory for the OS can be about 3GB or less. For effective use of memory, we recommend that you do any of the following:

a)Use��� a� maximum������� of�� 3GB��� system������ memory������ if�� you��� are��� using����� a� 32������-bit Windows������� OS���.

b)I�nstall������ a� 64������-bit Windows������� OS�� when���� you��� want���� to�� install������� 4GB��� or�� more���� on�� the���

motherboard.

c)For more details, refer to the Microsoft® support site at http://support.microsoft. com/kb/929605/en-us.

•This motherboard does not support������� �����DIMMs made���� up�� of�� 512Mb����� ������(64MB) chips����� or�� ����less (Memory chip capacity counts in Megabit, 8 Megabit/Mb = 1 Megabyte/MB).

• The��� default������� memory������ operation��������� frequency��������� is�� dependent��������� on�� its��� Serial������ Presence�������� Detect������

(SPD), which is the standard way of accessing information from a memory module. Under the default state, some memory modules for overclocking may operate at a lower frequency than the vendor-marked value. To operate at the vendor-marked or at a higher frequency, refer to section 3.4 Ai Tweaker menu for manual memory frequency adjustment.

•For��� system������ stability,���������� use��� a� more���� efficient��������� memory������ cooling������� system������ to�� support������� a� full����

memory load (4 DIMMs) or overclocking condition.

Chapter 1

ASUS M5A97 EVO R2.0

1-11