Memory configurations

You may install 1GB, 2GB, 4GB and 8GB unbuffered and non‑ECC DDR3 DIMMs into the DIMM sockets.

• Memory module with memory frequency higher than 2133 MHz and its corresponding timing or the loaded XMP profile is not the JEDEC memory standard. The stability and compatibility of these memory modules depend on the CPU’s capabilities and other installed devices.

•You may install varying memory sizes in Channel A and Channel B. The system maps the total size of the lower-sized channel for the dual-channel configuration. Any excess memory from the higher-sized channel is then mapped for single-channel operation.

•Due to Intel® 2nd generation processors' behavior, DDR3 2200 (and higher), and

DDR3 2000/1800 MHz memory modules will run at the default frequency rates of DDR3 2133/1866/1600 MHz.

•According to Intel CPU spec, DIMM voltage below 1.65V is recommended to protect the CPU.

•Always install DIMMs with the same CAS latency. For optimal compatibility, we recommend that you install memory modules of the same version or date code (D/C) from the same vendor. Check with the retailer to get the correct memory modules.

•Due to the memory address limitation on 32-bit Windows OS, when you install 4GB or more memory on the motherboard, the actual usable memory for the OS can be about 3GB or less. For effective use of memory, we recommend that you do any of the following:

a)Use a maximum of 3GB system memory if you are using a 32-bit Windows OS.

b)Install a 64-bit Windows OS when you want to install 4GB or more on the motherboard.

 

c) For more details, refer to the Microsoft® support site at http://support.microsoft.

 

com/kb/929605/en-us.

•

This motherboard does not support DIMMs made up of 512Mb (64MB) chips or less

 

(Memory chip capacity counts in Megabit, 8 Megabit/Mb = 1 Megabyte/MB).

 

 

 

 

•

The default memory operation frequency is dependent on its Serial Presence Detect

 

(SPD), which is the standard way of accessing information from a memory module.

 

Under the default state, some memory modules for overclocking may operate at a

 

lower frequency than the vendor-marked value. To operate at the vendor-marked or at

 

a higher frequency, refer to section 3.3 Extreme Tweaker menu for manual memory

 

frequency adjustment.

•

For system stability, use a more efficient memory cooling system to support a full

 

 

memory load (4 DIMMs) or overclocking condition.

Chapter 1

 

 

 

 

 

 

 

 

 

 

ASUS MAXIMUS V FORMULA Series

1-11