RAID support | 5 |
|
5.1RAID configurations
The motherboard comes with the AMD® SB950 chipset that allows you to configure Serial ATA hard disk drives as RAID sets. The motherboard supports the following RAID configurations: RAID 0, RAID 1, RAID 5 and RAID 10.
• You must install Windows® XP Service Pack 3 or later versions before using Serial ATA hard disk drives. The Serial ATA RAID feature is available only if you are using Windows® XP SP3 or later versions.
•Due to Windows® XP limitation, a RAID array with the total capacity over 2TB cannot be set as a boot disk. A RAID array over 2TB can only be set as a data disk only.
•If you want to install a Windows® operating system to a hard disk drive included in a RAID set, you have to create a RAID driver disk and load the RAID driver during OS installation. Refer to section 5.2 Creating a RAID driver disk for details.
5.1.1RAID definitions
RAID 0 (Data striping) optimizes two identical hard disk drives to read and write data in |
|
parallel, interleaved stacks. Two hard disks perform the same work as a single drive but at a |
|
sustained data transfer rate, double that of a single disk alone, thus improving data access |
|
and storage. Use of two new identical hard disk drives is required for this setup. |
|
RAID 1 (Data mirroring) copies and maintains an identical image of data from one drive to |
|
a second drive. If one drive fails, the disk array management software directs all applications |
|
to the surviving drive as it contains a complete copy of the data in the other drive. This RAID |
|
configuration provides data protection and increases fault tolerance to the entire system. Use |
|
two new drives or use an existing drive and a new drive for this setup. The new drive must be |
|
of the same size or larger than the existing drive. |
|
RAID 5 stripes both data and parity information across three or more hard disk drives. Among |
|
the advantages of RAID 5 configuration include better HDD performance, fault tolerance, and |
|
higher storage capacity. The RAID 5 configuration is best suited for transaction processing, |
|
relational database applications, enterprise resource planning, and other business systems. |
|
Use a minimum of three identical hard disk drives for this setup. |
|
RAID 10 is data striping and data mirroring combined without parity (redundancy data) having |
|
to be calculated and written. With the RAID 10 configuration you get all the benefits of both |
|
RAID 0 and RAID 1 configurations. Use four new hard disk drives or use an existing drive | 5 |
and three new drives for this setup. | |
| Chapter |
ASUS CROSSHAIR V |