Asus P4B533 10.Bass/Center setting (3-pinBCS1, BCS2) (on audio models only), 9.Line out selector (two 2-pinFP_LO_SWL, FP_LO_SWR) (on audio models only)

9.Line out selector (two 2-pin FP_LO_SWL, FP_LO_SWR) (on audio models only)

By default, these jumpers are shorted (jumper caps on) to route the signal from the audio controller to the rear panel Line Out jack to make it available for audio out devices such as speakers or a headphone.

If you connect the Intel Front Panel audio cable to the FP_AUDIO connector (see page 2-33 for the location), remove the caps from these jumpers to allow automatic switching of audio signal between the rear panel Line Out jack and the audio cable.

	FP_LO_SWL	BLOL
		FLOL
P4B533	FP_LO_SWR	BLOR
		FLOR

P4B533 Internal Line Out Connectors

10.Bass/Center setting (3-pin BCS1, BCS2) (on audio models only)

These jumpers allow you to select the speaker output for a 6-channel audio system. Switch the jumpers from the CENTER/BASS (pins 1-2) position to BASS/CENTER (pins 2-3) position to re-route signals on the internal leads of the Mic port.

Use the audio driver included in the support CD to install the multi- channel audio feature. See section “5.3 Software information.”

BCS1

BCS2

1 2 2 3

P4B533

	(CENTER/BASS) (BASS/CENTER)
P4B533 Bass Center Setting	(Default)

2-22 Chapter 2: Hardware information