5.RAID ATA/133/100/66/33 connector (40-1 pin PRI_RAID) (on RAID models only)

This connector supports either RAID 0 or RAID 1 configuration through the onboard Promise PDC20378 controller. You can connect two UltraATA 133 hard disks to this connector and set up a disk array configuration. You may also set up the UltraATA 133 hard disks with the Serial ATA hard disks on the Serial ATA RAID connectors to create a multi-RAID configuration. See Chapter 5 for details on RAID configuration.

PIN 1

PRI_RAID

NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1.

P4C800

P4C800 RAID Connector

If you wish to create a RAID set using UltraATA hard disks, make sure that you have connected the UltraATA cable and installed UltraATA 133 hard disks.

6.SMBus connector (6-1 pin SMB)

This connector allows you to connect SMBus (System Management Bus) devices. Devices communicate with an SMBus host and/or other SMBus devices using the SMBus interface.

P4C800

 

SMB

1

 

FLOATING SMBCLK

Ground SMBDATA +3V

P4C800 SMBus Connector

ASUS P4C800 Deluxe motherboard user guide

2-25