Asus P4P800S SE 5. Reboot the system from the hard disk

The BIOS information on the screen is for reference only. What you see on your screen may not be exactly the same as shown.

A:\>afudos /iP4P800SS.rom

AMI Firmware Update Utility - Version 1.10

Reading file ..... done

Erasing flash .... done

Writing flash .... 0x0008CC00 (9%)

DO NOT shutdown or reset the system while updating the BIOS! Doing so may cause system boot failure!

When the BIOS update process is complete, the utility returns to the DOS prompt.

A:\>afudos /iP4P800SS.rom

AMI Firmware Update Utility - Version 1.10

Reading file ..... done

Erasing flash .... done

Writing flash .... 0x0008CC00 (9%)

Verifying flash .. done

A:\>

5. Reboot the system from the hard disk.

ASUS P4P800S SE motherboard user guide

2-3

Contents

Page E1483 First Edition November Chapter 1: Product introduction Chapter 2: BIOS information Chapter 3: Software support Federal Communications Commission Statement •This device may not cause harmful interference, and •Reorient or relocate the receiving antenna •Increase the separation between the equipment and receiver •Consult the dealer or an experienced radio/TV technician for help Electrical safety Operation safety Conventions used in this guide Where to find more information ASUSTeK COMPUTER INC. (Asia-Pacific) Technical Support ASUS COMPUTER INTERNATIONAL (America) ASUS COMPUTER GmbH (Germany and Austria) ASUS COMPUTER (Middle East and North Africa) Page Page Page Latest processor technology DDR400 (PC3200) support Serial ATA technology AGP 8X support USB 2.0 technology 10/100 Mbps LAN support Page ATX power connector ATX 12V connector North bridge controller Super I/O controller Floppy disk connector LAN controller PCI slots AGP 8X slot 17PS/2 mouse port. This green 6-pinconnector is for a PS/2 mouse Parallel port 20.8cm( 8.2in) Super I/O Intel 30.5cm Page 1.7.1 Placement direction 1.7.2 Screw holes 1.8.1 Overview Notes on Intel® Hyper-ThreadingTechnology 1.8.2 Installing the CPU 1.9.1 Memory configurations Important notes Table 1 Memory frequency/CPU FSB synchronization Table 2 DDR400 Qualified Vendor List (QVL) DDR400 Qualified Vendor List (QVL) Important notes on ECC DIMMs 1.9.2 Installing a DIMM 1.10.1 Standard interrupt assignments 1.10.2 IRQ assignments for this motherboard 1.10.3 PCI slots 1.10.4AGP slot 1.Clear RTC RAM (CLRTC1) To erase the RTC RAM: 1.Turn OFF the computer and unplug the power cord 3.Plug the power cord and turn ON the computer Hold down the <Del> key during the boot process and enter BIOS setup to 2.USB device wake-up (3-pinUSBPW12, USBPW34, USBPW56, USBPW78) 3.Keyboard power (3-pinKBPWR1) 1.Floppy disk drive connector (34-1pin FLOPPY1) 2.ATX power connectors (20-pinATXPWR1, 4-pinATX12V1) 3. Serial ATA connectors (7-pinSATA2, SATA1) Important notes on Serial ATA solution: •Install Windows® XP™ Service Pack 1 when using Serial ATA Required IDE Configuration settings in BIOS 4.IDE connectors (40-1pin PRI_IDE1, SEC_IDE1) 5. Chassis intrusion connector (4-1pin CHASSIS1) 6.CPU and chassis fan connectors (3-pinCPU_FAN1, CHA_FAN1) 7.Internal audio connectors (4-pinMODEM1, CD1, AUX1) 8.USB header (10-1pin USB56, USB78) 9.Front panel audio connector (10-1pin FP_AUDIO1) 10.GAME/MIDI connector (16-1pin GAME1) 11.System panel connector (20 pin PANEL1) •System Power LED Lead (3-1pin PLED (green)) •System Warning Speaker Lead (4-pinSPKR (orange)) •Reset Switch Lead (2-pinRESET (blue)) •ATX Power Switch/Soft-offSwitch Lead (2-pinPWR (light green)) Page 2.1.1Creating a bootable floppy disk 2.1.2 Using AFUDOS to update the BIOS 5. Reboot the system from the hard disk 2.1.3 Using AFUDOS to copy BIOS from PC 2.1.4 Using ASUS EZ Flash to update the BIOS To update the BIOS using ASUS EZ Flash: 2.1.5 Recovering the BIOS with CrashFree BIOS To recover the BIOS from a floppy disk: To recover the BIOS from the support CD: Page BIOS menu screen 2.2.2 Menu bar 2.2.3 Navigation keys 2.2.4 Menu items 2.2.5 Sub-menuitems 2.2.6 Configuration fields 2.2.7 Pop-upwindow 2.2.8 Scroll bar 2.3.1 System Time [xx:xx:xxxx] 2.3.2 System Date [Day xx/xx/xxxx] 2.3.3 Legacy Diskette A [1.44M, 3.5 in.] Type [Auto] LBA/Large Mode [Auto] Block (Multi-sectorTransfer) [Auto] PIO Mode [Auto] DMA Mode [Auto] 2.3.5 IDE Configuration Onboard IDE Operate Mode [Enhanced Mode] Enhanced Mode Support On [S-ATA] IDE Port Settings [Primary P-ATA+S-ATA] IDE Detect Time Out [35] 2.3.6 System Information AMI BIOS Processor System Memory 2.4.1 JumperFree Configuration AI Overclock Tuner [Standard] CPU Ratio [12] Performance Mode [Auto] CPU External Frequency (MHz) [XXX] (value is auto-detected) DRAM Frequency [Auto] AGP/PCI Frequency (MHz) [Auto] CPU VCore Voltage [Auto] 2.4.2 CPU Configuration CPUID Maximum Value Limit [Disabled] Hyper-ThreadingTechnology [Enabled] 2.4.3 Chipset Configure DRAM Timing by SPD [Enabled] Memory Acceleration Mode [Auto] DRAM Idle Timer [Auto] DRAM Refresh Mode [Auto] DRAM CAS# Latency [2.5 Clocks] 2.4.4 Onboard Devices Configuration OnBoard AC’97 Audio [Auto] OnBoard LAN [Enabled] OnBoard LAN Boot ROM [Disabled] Serial Port1 Address [3F8/IRQ4] Parallel Port Address [378] Parallel Port Mode [ECP] ECP Mode DMA Channel [DMA3] Parallel Port IRQ [IRQ7] 2.4.5 PCI PnP Plug and Play O/S [No] PCI Latency Timer [64] Allocate IRQ to PCI VGA [Yes] Palette Snooping [Disabled] 2.4.6 USB Configuration USB Function [Enabled] Legacy USB Support [Auto] USB 2.0 Controller [Enabled] USB 2.0 Controller Mode [HiSpeed] USB Mass Storage Reset Delay [20 Sec] Emulation Type [N/A] 2.4.7 Instant Music Configuration Instant Music [Disabled] Instant Music CD-ROMDrive [IDE Secondary Master] 2.5.1 Suspend Mode [Auto] 2.5.2 Repost Video on S3 Resume [No] 2.5.3 ACPI 2.0 Support [No] 2.5.4 ACPI APIC Support [Enabled] 2.5.5 BIOS ->AML ACPI Table [Enabled] 2.5.6Advanced Power Management (APM) Configuration Power Management/APM [Enabled] Video Power Down Mode [Suspend] Hard Disk Power Down Mode [Suspend] Suspend Time Out [Disabled] Restore on AC Power Loss [Power Off] Power On By RTC Alarm [Disabled] Power On By External Modem [Disabled] Power On By PCI Devices [Disabled] Power On By PS/2 Keyboard [Disabled] 2.5.7 Hardware Monitor CPU Temperature [xxxC/xxxF] MB Temperature [xxxC/xxxF] CPU Fan Speed [xxxxRPM] or [N/A] Chassis Fan Speed [xxxxRPM] or [N/A] 2.6.1 Boot Device Priority 1st ~ xxth Boot Device [1st Floppy Drive] 2.6.2 Removable Drives 1st ~ xxth Boot Device [(Hard disk drive model name)] 2.6.3 Boot Settings Configuration Quick Boot [Enabled] Full Screen Logo [Enabled] Add On ROM Display Mode [Force BIOS] Bootup Num-Lock[On] PS/2 Mouse Support [Auto] Typematic Rate [Fast] 2.6.4 Security Change Supervisor Password User Access Level (Full Access] Change User Password Clear User Password Password Check [Setup] Boot Sector Virus Protection [Disabled] Exit & Save Changes Exit & Discard Changes Discard Changes Load Setup Defaults Page 3.2.1 Running the support CD 3.2.2 Drivers menu Intel® Chipset Inf Update program ADI AD1888 Audio Driver and Application USB 2.0 Driver REALTEK RTL8100C 10/100M LAN Driver 3.2.4 ASUS Contact Information To enable ASUS Instant Music Lite: To use ASUS Instant Music Lite: