2.USB device wake-up (3-pin USBPW12, USBPW34, USBPW56, USBPW78)

Set these jumpers to +5V to wake up the computer from S1 sleep mode (CPU stopped, DRAM refreshed, system running in low power mode) using the connected USB devices. Set to +5VSB to wake up from S3 and S4 sleep modes (no power to CPU, DRAM in slow refresh, power supply in reduced power mode).

The USBPWR12 and USBPWR34 jumpers are for the rear USB ports. The USBPWR56 and USBPWR78 jumper is for the internal USB header that you can connect to the front USB ports.

 

 

USBPW12

 

 

 

USBPW34

 

 

1

2

2

3

 

+5V

+5VSB

 

(Default)

 

 

 

 

USBPW56

 

 

 

USBPW78

 

P4P8X

1

2

2

3

 

 

 

 

P4P8X USB Device Wake Up

+5V

+5VSB

(Default)

 

 

1. The USB device wake-up feature requires a power supply that can provide at least 500mA on the +5VSB lead when these jumpers are set to +5VSB. Otherwise, the system would not power up.

2.The total current consumed must NOT exceed the power supply capability (+5VSB) whether under normal condition or in sleep mode.

3.Keyboard power (3-pin KBPWR)

This jumper allows you to enable or disable the keyboard wake-up feature. Set this jumper to pins 2-3 (+5VSB) if you wish to wake up the computer when you press a key on the keyboard (the default value is [Disabled]). This feature requires an ATX power supply that can supply at least 1A on the +5VSB lead and a corresponding setting in the BIOS. (see section 2.5.1 Power Up Control)

KBPWR

1

2

 

2

3

 

 

 

 

 

+5V +5VSB (Default)

P4P8X

P4P8X Keyboard Power Setting

1-20

Chapter 1: Product introduction