3.HARDWARE SETUP

15)Wake-On-LAN Connector (3-pin WOL)

This connector supports a LAN card with a Wake-On-LAN output. The connec- tor powers up the system when a wakeup packet or signal is received through the LAN card.

IMPORTANT: This feature requires that Wake On LAN or PCI Modem is enabled (see BIOS 4.5.1 Power Up Control) and that your system has an ATX power supply with at least 720mA +5V standby power.

 

IMPORTANT: Requires an ATX power

 

supply with at least 720mA +5 volt

 

standby power

P4T-CM

WOL_CON

 

 

+5 Volt Standby PME

 

Ground

P4T-CM Wake-On-LAN Connector

16)USB Headers (10-1 pin USB2)

If the USB Ports on the back panels are inadequate, a USB header is available for two additional USB ports. Connect the 10-1 pin ribbon cable from the pro- vided 2-port USB connector set to the midboard 10-1 pin USB header and mount the USB connector set to an open slot on your chassis.

USB2

10

6

P4T-CM

 

5

1

1: USB Power

6: USB Power

2: USBP2–

7: USBP3–

3: USBP2+

8: USBP3+

4: GND

9: GND

5: NC

 

P4T-CM USB Headers

.3 SETUPH/W

Connectors

ASUS P4T-CM User’s Manual

31