Asus P4V800-X NorthBridge VIA P4X400/PT800 Configuration, Configure DRAM Timing by SPD [Enabled], SDRAM Burst Length [4QW], SDRAM Command Rate [2T]

NorthBridge VIA P4X400/PT800 Configuration

******** DRAM Timing ********	[Enabled]
Configure SDRAM Timing by SPD
SDRAM Frequency	[Auto]
SDRAM Burst Length	[4QW]
SDRAM Command Rate	[2T]
Primary Graphics Adapter	[AGP]
V-Link 8X Supported	[Enabled]
AGP Mode	Auto
Graphics Aperture Size	[64MB]

Select Screen

Select Item

+- Change Option

F1 General Help

F10 Save and Exit

ESC Exit

Configure DRAM Timing by SPD [Enabled]

When this item is enabled, the DRAM timing parameters are set according to the DRAM SPD (Serial Presence Detect). When disabled, you can manually set the DRAM timing parameters through the DRAM sub-items. Configuration options:

[Disabled] [Enabled]

The following sub-items appear when the item Configure DRAM Timing by SPD is set to Disabled.

SDRAM Frequency [Auto]

Allows you to set the SDRAM operating frequency.

Configuration options: [266Mhz] [333Mhz] [400Mhz] [Auto]

DRAM CAS# Latency [2.5]

This item controls the latency between the SDRAM read command and the time the data actually becomes available. Configuration options: [1.0 Clocks] [2.0 Clocks] [2.5 Clocks] [3.0 Clocks]

SDRAM Bank Interleave [Disabled]

This item controls the latency between the SDRAM read command and the time the data actually becomes available.

Configuration options: [Disabled] [2-Way] [4-Way]

SDRAM Burst Length [4QW]

Configuration options: [8QW] [4QW]

SDRAM Command Rate [2T]

Configuration options: [2T] [1T]

2-18 Chapter 2: BIOS information