Asus P5B-E P5B-EChassis intrusion connector, 8.Chassis intrusion connector (4-1pin CHASSIS), 9.ATX power connectors (24-pinEATXPWR, 4-pinEATX12V)

8.Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event.

By default , the pin labeled “Chassis Signal” and “ Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

P5B-E

+5VSB_MB	Chassis Signal GND
CHASSIS	(Default)
P5B-E Chassis intrusion connector

9.ATX power connectors (24-pin EATXPWR, 4-pin EATX12V)

These connectors are for ATX power supply plugs. The power supply plugs are designed to fit these connectors in only one orientation. Find the proper orientation and push down firmly until the connectors completely fit.

	EATX12V				EATXPWR
P5B-E	+12V DC	+12V DC		+3	Volts	Ground
	GND	GND
				+12	Volts	+5 Volts
				+12	Volts	+5 Volts
			+5V Standby			+5 Volts
				Power OK		-5 Volts
				Ground		Ground
				+5	Volts	Ground
				Ground		Ground
				+5 Volts		PSON#
				Ground		Ground
P5B-E ATX power connectors				+3	Volts	-12 Volts
				+3 Volts		+3 Volts

•Make sure to remove the cap on the EATX12V connector before connecting an 4-pin EPS +12V power plug.

•Use only 4-pin ATX12V EPS +12V power plug for the EATX12V connector.

ASUS P5B-E 2-31