Refer to the audio configuration table below for the function of the audio ports in 2, 4, 6, or 8-channel configuration.

Audio 2, 4, 6, or 8-channel configuration

Port

Headset

4-channel

6-channel

8-channel

 

2-channel

 

 

 

Light Blue

Line In

Line In

Line In

Line In

Lime

Line Out

Front Speaker Out

Front Speaker Out

Front Speaker Out

Pink

Mic In

Mic In

Mic In

Mic In

Orange

–

–

Center/Subwoofer

Center/Subwoofer

Black

–

Rear Speaker Out

Rear Speaker Out

Rear Speaker Out

Gray

–

–

–

Side Speaker Out

11.USB 2.0 ports 1 and 2. These two 4-pin Universal Serial Bus (USB) ports are available for connecting USB 2.0 devices.

12.USB 2.0 ports 3 and 4. These two 4-pin Universal Serial Bus (USB) ports are available for connecting USB 2.0 devices.

13.VGA port. This port is for a VGA monitor or other VGA-compatible devices.

14.External SATA port. This port connects to an external Serial ATA hard disk drive. To configure a RAID 0, a RAID 1, or a JBOD set, install and external

Serial ATA hard disk drive and an internal Serial ATA hard disk drive to the SATA connector labeled SATA_RAID or SATA_RAID1.

The external SATA port supports external Serial ATA 3.0 Gb/s devices. Longer cables support higher power requirements to deliver signal up to two meters away, and enables improved hot-swap function.

• Before creating a RAID set using Serial ATA hard disks, make sure that you have connected the Serial ATA signal cable and installed Serial ATA hard disk drives; otherwise, you cannot enter the JMicron RAID utility and SATA BIOS setup during POST.

•If you intend to create a RAID configuration using this connector, set the

JMicron SATA Controller Mode item in the BIOS to [RAID]. See section

“2.4.6 Onboard Device Configuration” for details.

• DO NOT insert a different connector to this port.

• DO NOT unplug the external SerialATAbox when a RAID 0 or JBOD is configured.

15.PS/2 keyboard port (purple). This port is for a PS/2 keyboard.

ASUS P5B-VM DO

1-31