9. Front panel audi o connector (10-1 pi n AAFP)

This connector is for a chassis-mounted front panel audio I/O module that supports either HD Audio or legacy AC’97 audio standard.

P5GZ-MX

Azalia-compliant

Legacy AC’97-compliant

pin definition

pin definition

AGND PRESENSE# MIC2 JD

HP HD

AGND NC NC

NC

AAFP

 

 

 

MIC2_L MIC2_R HP_R Jack_Sense HP_L

MIC2_L MIC2_R Line out_R NC Line out_L

P5GZ-MX Front Panel Audio Connector

• We recommend that you connect a high-definition front panel audio module to this connector to avail of the motherboard’s high- definition audio capability.

• By default, this connector is set to AC97 Audio. If you want to connect a High Definition front panel audio module to this connector, set the Front Panel Support Type item in the BIOS to [HD Audio]. See section “2.4.6 Onboard Device Configuration” for details.

10. Chassi s i ntrusi on connector (4-1 pi n CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component

is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pins labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

P5GZ-MX

+5VSB MB

Chassis Signal GND

CHASSIS

(Default)

P5GZ-MX Intrusion Connector

ASUS P5GZ-MX

1-33