5.4.3JMicron® RAID Configuration

The JMicron® Serial ATA controller allows you to configure RAID 0, RAID 1 and JBOD sets on the external Serial ATA hard disk drives.

Before creating a RAID set

Prepare the following items:

1.Two SATA HDDs, preferably with the same model and capacity.

2.A write-enabled floppy disk (Windows XP). A write-enabled floppy disk or a USB flash disk drive (Windows Vista)

3.Microsoft® Windows® OS installation disk (Windows 2000/XP)

4.Motherboard support CD with JMB363 driver

Complete the following steps before you create a RAID set:

1.Install the two external Serial ATA hard disk drives to your system.

2.Set the Controller Mode item in the BIOS to [RAID]. See section 4.4.5

Onboard Devices Configuration for details.

BIOS SETUP UTILITY

 

Advanced

 

 

 

 

 

Onboard Device Configuration

 

 

Enable or Disable

High Definition Audio

[Enabled]

High Definition Audio

Controller

Front Panel Type

[HD Audio]

 

 

J-Micron eSATA/PATA Controller

[Enabled]

 

 

Controller Mode

[RAID]

 

 

 

Marvell GigaBit LAN

[Enabled]

 

 

 

LAN Boot ROM

[Disabled]

 

 

Wireless LAN

[Enabled]

 

 

Agere Firewire 1394

[Enabled]

 

 

Serial Port1 Address

[3F8/IRQ4]

 

Select Screen

 

 

 

 

 

 

 

 

 

 

 

 

Select Item

 

 

 

 

 

+-

Change Option

 

 

 

 

 

F1

General Help

 

 

 

 

 

F10

Save and Exit

 

 

 

 

 

ESC

Exit

v02.58 (C)Copyright 1985-2007, American Megatrends, Inc.

3.Enter the JMB363 RAID BIOS utility to set up your RAID configuration.

4.Create a JMB363 RAID driver disk for Windows® OS installation. Refer to section 5.5 Creating a RAID driver disk for details.

5.Install the JMB363 driver after the Windows® OS had been installed.

Always install the JMB363 driver before creating RAID sets.

ASUS P5K-E

5-35