P5K3 DELUXE

P5K3 DELUXE IDE connector

PRI_EIDE

PIN 1

NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1.

3.ICH9R Serial ATA connectors (7-pin SATA1 [red], SATA2 [red], SATA3 [black], SATA4 [black], SATA5 [red], SATA6 [red])

These connectors are for the Serial ATA signal cables for Serial ATA hard disk drives.

If you installed Serial ATA hard disk drives, you can create a RAID 0 and RAID 1 configuration with the Intel® Matrix Storage Technology through the onboard Intel® ICH9R RAID controller.

•These connectors are set to Standard IDE mode by default. In Standard IDE mode, you can connect Serial ATA boot/data hard disk drives to these connectors. If you intend to create a Serial ATA RAID set using these connectors, set the Configure SATA as item in the BIOS to [RAID]. See section 4.3.6 SATA Configuration for details.

•Before creating a RAID set, refer to 5.4.2 Intel RAID Configuration or the manual bundled in the motherboard support DVD.

 

SATA1

DELUXE

SATA2

P5K3

 

SATA5

P5K3 DELUXE SATA connectors

GND RSATA_TXP1 RSATA_TXN1

GND RSATA_RXP1 RSATA_RXN1

GND

GND RSATA_TXP2 RSATA_TXN2

GND RSATA_RXP2 RSATA_RXN2

GND

GND RSATA_TXP5 RSATA_TXN5

GND RSATA_RXP5 RSATA_RXN5

GND

GND RSATA_TXP3 RSATA_TXN3

GND RSATA_RXP3 RSATA_RXN3

GND

GND RSATA_TXP4 RSATA_TXN4

GND RSATA_RXP4 RSATA_RXN4

GND

GND RSATA_TXP6 RSATA_TXN6

GND RSATA_RXP6 RSATA_RXN6

GND

SATA3

SATA4

SATA6

2-26

Chapter 2: Hardware information