2.7.2Internal connectors

1.Floppy disk drive connector (34-1 pin FLOPPY)This connector is for the provided floppy disk drive (FDD) signal cable.

Insert one end of the cable to this connector, then connect the other end to the signal connector at the back of the floppy disk drive.

Pin 5 on the connector is removed to prevent incorrect cable connection when using a FDD cable with a covered Pin 5.

P5LD2

FLOPPY

PIN 1

NOTE: Orient the red markings on the floppy ribbon cable to PIN 1.

P5LD2 Floppy disk drive connector2.ITE IDE connectors (40-1 pin PRI_EIDE [red], SEC_EIDE [red])

These connectors are for Ultra ATA 133/100/66 signal cables. The ITE IDE connectors support up to four IDE hard disk drives for easier

data storage and data transfer.

P5LD2

P5LD2 RAID connectors
SEC_EIDE

PIN 1

PRI_EIDE

PIN 1 NOTE: Orient the red markings (usually zigzag) on the IDE ribbon cable to PIN 1.

•Make sure that you install the ITE 8211 IDE Driver from the support CD before using the IDE device attached to any of these connectors. See Chapter 5 for details.

•These connectors do not support ATAPI devices.

2-24

Chapter 2: Hardware information