Asus P5PL2-E P5PL2-EDigital Audio Connector, 3. Digitalaudio connector (4-1pin SPDIF), 2. ICH7 Primary IDEconnector (40-1pin PRI_IDE)

2. I CH 7 Pri mary I DE connector (40-1 pi n PRI _I DE)

This connector is for an Ultra DMA 100/66 signal cable. The Ultra DMA 100/66 signal cable has three connectors: a blue connector for the primary IDE connector on the motherboard, a black connector for an Ultra DMA 100/66 IDE slave device (optical drive/hard disk drive), and a gray connector for an Ultra DMA 100/66 IDE master device (hard disk drive). If you install two hard disk drives, you must configure the second drive as a slave device by setting its jumper accordingly. Refer to the hard disk documentation for the jumper settings.

• Pin 20 on the IDE connector is removed to match the covered hole on the Ultra DMA cable connector. This prevents incorrect insertion when you connect the IDE cable.

•Use the 80-conductor IDE cable for Ultra DMA 100/66 IDE devices.

P5PL2-E

P5PL2-E IDE Connector

PRI_IDE

PIN1

NOTE: Orient the red markings (usually zigzag) on the ID ribbon cable to PIN 1.

3. Di gi tal audi o connector (4-1 pi n SPDIF)

This connector is for an additional Sony/Philips Digital Interface (S/ PDIF) port(s). Connect the S/PDIF Out module cable to this connector, then install the module to a slot opening at the back of the system chassis.

P5PL2-E +5V SPDIFOUT GND

SPDIF_OUT

P5PL2-E Digital Audio Connector

The S/PDIF module is purchased separately.

ASUS P5PL2-E 2-23