
These connectors are for the Serial ATA signal cables for Serial ATA hard disk drives.
If you installed Serial ATA hard disk drives, you can create a RAID 0, RAID 1, RAID 0+1, and JBOD configuration using the ULI® RAID controller. Refer to Chapter 5 for details on how to set up Serial ATA RAID configurations.
Enable the Serial ATA Controller item in the BIOS if you want to use the Serial ATA RAID feature. See the SouthBridge Configuration for details.
SATA3
SATA1
GND RSATA_TXP3
RSATA_TXN3
GND RSATA_RXP3
RSATA_RXN3
GND
GND RSATA_TXP1
RSATA_TXN1
GND RSATA_RXP1
RSATA_RXN1
GND
SATA4
SATA2
GND RSATA_TXP4
RSATA_TXN4
GND RSATA_RXP4
RSATA_RXN4
GND
GND RSATA_TXP2
RSATA_TXN2
GND RSATA_RXP2
RSATA_RXN2
GND
•Due to chipset limitation, you cannot configure a RAID 0 set or JBOD with more than two hard disk drives.
•Install the Windows® 2000 Service Pack 4 or the Windows® XP Service Pack1 or later when using Serial ATA.
2 - 26 | Chapter 2: Hardware information |