8.Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event.

By default , the pin labeled “Chassis Signal” and “ Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

CHASSIS

+5VSB MB

Chassis Signal GND

P5SD2-VM

(Default)

P5SD2-VM Intrusion Connector

9.Front panel audio connector (10-1 pin AAFP)

This connector is for a chassis-mounted front panel audio I/O module that supports either HD Audio or legacy AC`97 audio standard. Connect one end of the front panel audio I/O module cable to this connector.

P5SD2-VM

Azalia-compliant

Legacy AC’97-compliant

pin definition

pin definition

AGND PRESENSE# MIC2 JD

HP HD

AGND NC NC

NC

AAFP

 

 

 

MIC2_L MIC2_R HP_R Jack_Sense HP_L

MIC2_L MIC2_R Line out_R NC Line out_L

P5SD2-VM Front Panel Audio Connector

•We recommend that you connect a high-definition front panel audio module to this connector to avail of the motherboard’s high-definition audio capability.

•By default, this connector is set to HD Audio.

ASUS P5SD2-VM

1-33