Asus P8H61-M2/C/SI, P8H61-M2/SI, P8H61-M2/TPM/SI P8H61-M2/TPM/SIDigital audio connector, P8H61-M2/TPM/SIChassis intrusion connector, 10.Digital audio connector (4-1pin SPDIF_OUT)

10.Digital audio connector (4-1 pin SPDIF_OUT)

This connector is for an additional Sony/Philips Digital Interface (S/PDIF) port.

+5V SPDIFOUT GND

P8H61-M2/TPM/SI

SPDIF_OUT

P8H61-M2/TPM/SI Digital audio connector

The S/PDIF module is purchased separately.

11.Chassis intrusion connector (4-1 pin CHASSIS)

This connector is for a chassis-mounted intrusion detection sensor or switch. Connect one end of the chassis intrusion sensor or switch cable to this connector. The chassis intrusion sensor or switch sends a high-level signal to this connector when a chassis component is removed or replaced. The signal is then generated as a chassis intrusion event.

By default, the pin labeled “Chassis Signal” and “Ground” are shorted with a jumper cap. Remove the jumper caps only when you intend to use the chassis intrusion detection feature.

	CHASSIS
P8H61-M2/TPM/SI	GND
	Chassis Signal

+5VSB_MB

P8H61-M2/TPM/SI Chassis intrusion connector

Chapter 1: Product introduction 1-15