These connectors are for ATX power supply plugs. The power supply plugs are designed to fit these connectors in only one orientation. Find the proper orientation and push down firmly until the connectors completely fit.
ATX12V EATXPWR
+12V DC +12V DC
PIN 1
GND
GND
+3 Volts
+12 Volts
+12 Volts
+5V Standby
Power OK
GND
+5 Volts
GND
+5 Volts
GND
+3 Volts
+3 Volts
PIN 1
GND
+5 Volts
+5 Volts
+5 Volts
GND
GND
GND PSON#
GND
• For a fully configured system, we recommend that you use a power supply unit (PSU) that complies with ATX 12 V Specification 2.0 (or later version) and provides a minimum power of 350 W.
•DO NOT forget to connect the
•We recommend that you use a PSU with higher power output when configuring a system with more
•If you are uncertain about the minimum power supply requirement for your system, refer to the Recommended Power Supply Wattage Calculator at http://support.asus.
These connectors connect to Serial ATA 3.0 Gb/s hard disk drives and optical drives via Serial ATA 3.0 Gb/s signal cables.
SATA3G_1 | SATA3G_2 |
GND RSATA TXP1 RSATA TXN1 GND RSATA RXN1 RSATA RXP1 GND | GND RSATA TXP2 RSATA TXN2 GND RSATA RXN2 RSATA RXP2 GND |
SATA3G_3 | SATA3G_4 |
GND RSATA RXP3 RSATA RXN3 GND RSATA TXN3 RSATA TXP3 GND | GND RSATA RXP4 RSATA RXN4 GND RSATA TXN4 RSATA TXP4 GND |
• You must install Windows® XP Service Pack 3 or later version before using Serial ATA hard disk drives.
•When using
ASUS |