9.Intel® H77 Serial ATA 3.0Gb/s connectors (7-pin SATA3G_1~4 [blue])

These connectors connect to Serial ATA 3.0 Gb/s hard disk drives and optical drives via Serial ATA 3.0 Gb/s signal cables.

If you installed Serial ATA hard disk drives, you can create a RAID 0, 1, 5, and 0+1(10) configurations with the Intel® Rapid Storage Technology through the onboard Intel® H77 chipset.

P8H77-V LE

SATA3G_3

SATA3G_2

SATA3G_1

GND RSATA TXP3 RSATA TXN3 GND RSATA RXN3 RSATA RXP3 GND

GND RSATA TXP2 RSATA TXN2 GND RSATA RXN2 RSATA RXP2 GND

GND RSATA TXP1 RSATA TXN1 GND RSATA RXN1 RSATA RXP1 GND

SATA3G_4

 

 

GND RSATA RXP4 RSATA RXN4 GND RSATA TXN4 RSATA TXP4 GND

 

 

 

 

 

 

 

 

P8H77-V LE SATA 3.0Gb/s connectors

•These connectors are set to [AHCI] by default. If you intend to create a Serial ATA RAID set using these connectors, set the SATA Mode Selection item in the BIOS to [RAID].

See section 2.5.3 SATA Configuration for details.

•Before creating a RAID set, refer to the RAID Supplementary Guide included in the folder named Manual in the support DVD.

•You must install Windows® XP Service Pack 3 or later version before using Serial ATA hard disk drives. The Serial ATA RAID feature (RAID 0, 1, 5, and 10) is available only if you are using Windows® XP SP3 or later version.

•When using hot-plug and NCQ, set the SATA Mode Selection item in the BIOS to

[AHCI]. See section 2.5.3 SATA Configuration for details.

1-30

ASUS P8H77-V LE