Asus PCEN10 3.3 Soft AP mode (Windows XP/Vista/7)

PCE-N10 WLAN Card User Manual

12 ASUS WLAN Card

2. Click General table and then click

ICS to enable ICS. The General table

displays the wireless clients that are

currently connecting to the Soft AP.

3. Select a network(station) from the

available networks list, then click

Apply.

To switch to the Soft AP mode:

1. Click AP to switch to the Soft AP

mode.

3.3 Soft AP mode (Windows® XP/Vista/7)

The ASUS PCE-N10 WLAN Card supports the Soft AP mode. In this mode, the

WLAN card acts as a virtual AP.

The picture indicates that your WLAN

card has switched to the Soft AP

mode successfully.

• The ASUS WLAN Card Setting

Utility icon in the system tray

switches to the ASUS Wireless

Access Point Utility icon .

IMPORTANT: Before conguring the Soft AP mode, connect your computer to a

wired network to provide network access for your wireless clients.

Contents

Main Page Manufacturer contact information Table of contents Notices Federal Communications Commission Prohibition of Co-location FCC Radiation Exposure Statement CE Mark Warning DGT Warning Statement Article 12 Article 14 IC Warning Statement IC Radiation Exposure Statement: ASUS Recycling/Takeback Services REACH ASUS WLAN Card EC Declaration of Conformity Page 1. Introduction 1.2 System requirements 1.1 Package contents 1.3 Hardware Status indicator LED Status Description 2. Installing the PCE-N10 driver and utilities 3.1 Connecting to a wireless network manually 3. Conguring PCE-N10 using ASUS utility 3.2 Connecting to a wireless network using WPS Page 3.3 Soft AP mode (Windows XP/Vista/7) Page 4.1 ASUS WLAN Control Center 4. Software information 4.2 ASUS WLAN Card Setting Utility ASUS WLAN Card Setting Utility system tray icon Page Cong - Basic Others Cong - Encryption Cong - Advanced Page 6. Troubleshooting How do I verify that my WLAN card is installed properly? My WLAN card cannot connect to any Access Points. My WLAN card cannot connect to a station or WLAN card. The connection quality is bad and the signal strength is weak. The TCP/IP protocol does not bind to the WLAN Card. 7. Glossary COFDM (for 802.11a or 802.11g) Default Key Device Name DHCP (Dynamic Host Conguration Protocol) DNS Server Address (Domain Name System) DSL Modem (Digital Subscriber Line) Direct-Sequence Spread Spectrum (for 802.11b) Page ICS IEEE IEEE 802.11 IEEE 802.11a (54Mbits/sec) Compared with 802.11g: IEEE 802.11b (11Mbits/sec) IEEE 802.11g Infrastructure Page Page Page WPA (Wi-Fi Protected Access) Requirements WLAN (Wireless Local Area Network)