4.4.2Installing Serial ATA hard disks
The motherboard supports Serial ATA hard disk drives. For optimal performance, install identical drives of the same model and capacity when creating a disk array.
To install the SATA hard disks for a RAID configuration:
1.Install the SATA hard disks into the drive bays.
2.Connect the SATA signal cables.
3.Connect a SATA power cable to the power connector on each drive.
4.4.3Intel® RAID configurations
This motherboard supports RAID 0, RAID 1, RAID 5, RAID 10 and Intel® Matrix Storage configurations for Serial ATA hard disks drives through the Intel® ICH10R Southbridge chip.
Setting the RAID item in BIOS
You must set the RAID item in the BIOS Setup before you can create a RAID set(s). To do this:
1.Enter the BIOS Setup during POST.
2.Go to the Main menu, select Storage Configuration, then press <Enter>.
3.Select the item Configure SATA as, then press <Enter> to display the configuration options.
4.Select [RAID] from the Configure SATA as item options, then press <Enter>.
5.Save your changes, then exit the BIOS Setup.
Refer to the system or the motherboard user guide for details on entering and navigating through the BIOS Setup.
Chapter 4: Software support |