2.9Installing an optical drive

The Terminator 2 system comes with two 5.25-inch drive bays for two optical drives.

¥ You may install a second optical drive only if you installed a Serial ATA hard disk drive.

¥Set your second optical drive as Slave device before connecting the IDE cable and power plug. Refer to the optical drive documentation on how to set the drive as a Slave device.

To install an optical drive:

1.Place the chassis upright.

2.

Locate the front panel cover

3

3

 

hooks.

 

 

 

3.

To remove the front panel cover

1

 

 

from the chassis, press the top

 

2

 

hooks downward and the

 

 

 

bottom hooks upward to release

 

 

 

them from the metal tabs that

3

 

 

secure them in place.

3

 

 

4.

Detach the front panel cover

 

 

 

top hooks.

4

 

4

5.Slightly push the front panel

cover outward until it detaches from the chassis, then set it aside.

On Deluxe models, disconnect

 

the LED panel and the front

5

audio button panel cables from their respective connectors before removing the front panel cover.

To reconnect the cables, see pages 4-7 and 4-8 for the location of the connectors.

2 - 14

Chapter 2: Basic installation