AT&T 5830 Wall Installation

Wall Installation
1 Connect the power cord and
telephone line cord to the underside
of the corded base, as shown
(figure a).
2 Position the mounting bracket as
shown (figure b).
3 Feed the telephone line cord through
the hole in the center of the
mounting bracket (figure b), align
the bracket with the base, and slide
into the hole on the base as shown
(figure c).
4 Lock the mounting bracket in place
(figure d).
5 Plug the telephone line cord into a
modular wall jack, and mount the
base on the wall (figure e).
a) Align holes on base with mounting
studs on wall jack.
b) Place power cord as shown.
c) Pull base down on mounting studs
until it locks into place.
6 Plug the power cord into an
electrical outlet not controlled by a
wall switch (figure e).
Use only the power cord supplied
with this product. If you need a
replacement,call 1 800 222–3111.
7 Follow Steps 3–5 in “Table/Desktop
Installation.”
5
INSTALLATION
INSTALLATION
figure a
figure b
figure c
figure d
figure e
5830_CIB_1ATT 2002.11.8 10:31 AM Page 5