AT&T 9210 Wall Installation, Connect the, telephone, line cord, I N S T A L L A T I O N, Modular

Models: 9210

1 8

Page 3

I N S T A L L A T I O N

Standard electrical outlet

2Connect the power cord.

Place power cord as shown, so it hangs straight down between base and wall.

Use only the power cord supplied with this product. If you need a replacement, call 1 800 222-3111.

3Mount the base on the wall.

Align holes on base with mounting studs on wall jack.

Pull base down on mounting studs until it locks into place.

4Follow Steps 3–5 in “Table/Desk Installation.”

Image 3

Contents

USER’S MANUAL also read Part 1 - Important Product Information900 MHz Cordless Telephone REVISED 10/17/00Before You Install Table/Desk InstallationI N S T A L L A T I O N line cord Wall InstallationConnect the telephoneT E L E P H O N E O P E R A T I O N Handset VolumeBattery Save Cancel a pageT E L E P H O N E O P E R A T I O N Page Handset LocatorIndicates handset is in use Indicates handset is charging in baseStore a Pause T E L E P H O N E M E M O R YStore Memory Numbers Dial Memory NumbersO P E R A T I N G R A N G E Charging the Handset Battery PackReplacing the Handset Battery Pack B A T T E R I E SIf you hear noise or interference when using the phone I N C A S E O F D I F F I C U L T YIf you hear a two-beep signal when you try to use the handset If the phone does not ring when you receive a call