AT&T E6012B, E3813B, E6014B Installation and setup, Avoid placing the telephone base too close to

Installation and setup

Choose a central location close to a telephone jack and a power outlet not connected to a wall switch. The telephone base can be placed on a flat sur- face or mounted on a standard wall plate. For optimum range and better reception, place the telephone base in a high and open location.

Avoid placing the telephone base too close to:

•Communication devices such as: personal computers, computer routers, tel- evision sets, VCRs, wireless routers (wireless broadband, wi-fi, or 802.11) or other cordless telephones.

•Excessive heat sources.

•Noise sources such as a window with traffic outside, motors, microwave ovens, refrigerators, or fluorescent lighting.

•Excessive dust sources such as a workshop or garage.

•Excessive moisture.

•Extremely low temperatures.

•Mechanical vibration or shock such as on top of the washing machine or work bench.

1.Plug one end of the telephone line cord into the telephone jack at the bottom of the telephone base.

2.Plug the small end of the larger power adapter into the power jack at the bottom of the telephone base.

5.Plug the other end of the telephone line

cord into a telephone jack.

Telephone line cord DSL filter

(Optional for DSL users, see number four in the NOTES section, below.)

3. Route cords through slots.

4. Plug the large end of the larger power adapter into an electrical outlet not control- led by a wall switch.

NOTES:

1.Use only the power cord supplied with this product, if you need a replacement, call 1 (800) 222-3111, in Canada dial 1 (866) 288-4268. Or visit our website at www.telephones.att.com.

2.Be sure to use an electrical outlet not controlled by a wall switch.

3.This power adapter is intended to be plugged into a vertical wall outlet or a floor outlet. The prongs are not designed to hold the plug in place if it is plugged into a ceiling, under-the- table or cabinet outlet.

4.If you receive high speed internet through your telephone line (coming referred to as DSL), and you are experiencing inference during telephone conversations and/or your caller ID fea- tures are not functioning properly, install a DSL filter to the telephone line between the tel- ephone base and the telephone wall jack. Contact your DSL service provider for a DSL filter.