AT&T E580-1 user manual Battery installation & charging, Low battery indicator

ATT-580-1CIB-d2.qxd 1/17/2004 6:13 PM Page 2

Battery installation & charging

After installation, place the handset in the charger and allow batteries to charge for 12 hours before use. You can keep batteries charged by returning the handset to the charger after each use. When battery power is fully depleted, a full recharge takes about 8 hours.

1

LOW BATTERY

Press coin into slot on base of handset to release latch, then remove battery cover.

To replace battery cover

Insert top tab first.

Caution: Use only the supplied NiMH battery (80-5461-00-00) or AT&T model 2AA NiMH replace- ment battery (SKU 26820). Do not use alkaline batteries.

REDIAL 2:10 PM CID LOG

Low battery indicator

Return handset to charger to recharge when this symbol flashes. (Handset will beep when battery is low.)

Insert supplied batteries.

Plug power cord into jack on underside of charger, then plug transformer into electrical outlet.

Press down to click in place.

Place handset in charger to charge for 12 hours before first use.

Light remains on while batteries are charging.

2