Getting started

Battery installation & charging

After battery installation, the battery may have enough charge to allow for some calls. For best performance, place the handset in the charger or telephone base and allow it to charge for 16 hours before use. You can keep the battery charged by returning the handset to the charger or the telephone base after each use. When the battery is fully depleted, a recharge takes about 12 hours. The average talk time on a fully charged battery is about eight hours depending on environmental conditions, and the standby time when idle is approximately five days.

1.Plug the small end of the smaller power adapter into the jack on the underside of char- ger, then route the cord through the slot as shown.

2.Plug the large end of the smaller power adapter into an electrical

outlet.

3. Plug the battery securely into the plug inside the handset battery compartment, matching the color- coded label.

4. Place the

5. Slide battery

battery and

compartment

wires neatly

cover towards

inside the com-

the center until

partment.

it clicks closed.

TONE

6.The battery may have enough charge to allow for some calls. For best performance, place handset in the telephone base or charger to charge for at lease 16 hours before first use.

LOW BATTERY

Low batt��er�y indicat�or� Return handset to the telephone base or char- ger to recharge when this symbol flashes. (Handset will beep when battery is low.)

To replace the battery, press in and downward on the tab to open the battery compart- ment cover. Then lift out the old battery and disconnect.

Follow the instructions on this page to install and charge the new battery.

Caut�ion: Use only the supplied rechargeable battery or AT&T replacement battery model 27910 (part number 89-0099-00-00). To order, visit our website at www.telephones.att.com or call 1 (800) 222-3111. In Canada dial 1 (866) 288-4268.



Page 3
Image 3
AT&T E598-2 quick start Battery installation & charging, LOW Battery