AT&T SL82118, SL82658, SL82558 Telephone base & charger installation, Telephone base installation

Getting started

Telephone base & charger installation

Install the telephone base as shown below. Make sure that the electrical outlet is not controlled by a wall switch.

If you subscribe to high-speed Internet service (Digital Subscriber Line - DSL) through your telephone lines, you must install a DSL filter between the telephone base and the telephone wall jack. The filter will prevent noise and caller ID problems caused by DSL interference. Please contact your DSL service provider for more information about DSL filters.

The telephone base comes with the mounting bracket installed for desktop use. Also, the telephone line cord and the power adapter are already plugged into the telephone base. If you want to change to wall mounting installation, see page 10 for details.

Telephone base installation

1.Plug the other end of the telephone line cord into a telephone jack.

Telephone line cord

Power adapter

DSL filter (not included), required if you have DSL high-speed Internet service.

4. Raise the antenna.

2.Plug the power adapter into an outlet not controlled by a wall switch.

3.Make sure the telephone line cord and power adapter cord are routed through the slots on the bracket.