Stagehand User’s Manual, page 7
• After your laptop or desktop computer is powered on and fully booted up, plug the
Stagehand USB receiver into the computer’s USB port.
A solid color LED on the USB receiver indicates the receiver has power from the
computer. The LED flashes when it receives keyboard command signals from the
remote control, but do not push any buttons on the remote control yet.
Do NOT push the button on the receiver (the remote control and receiver are already
preset in the factory to communicate with each other).
Wait until the pop-up message on your computer screen says that the installation is
complete and the device is ready to use before using the remote control.
• Optionally install the enclosed neck lanyard per the separate safety warning and
installation instructions that come with the lanyard.
Remember to turn the remote control off after use to extend battery life and prevent
accidental battery drain.
Read the Operation section below for detailed instructions on how to use your
Stagehand.
Installation