Installation

Setting up the CE-220 KVM Extender system is simply a matter of plugging in the cables. Refer to the installation diagram on the following page and do the following:

1.Make sure that all the equipment to be connected up is powered Off.

2.Plug the cables from the local console devices (mouse, keyboard, monitor), into their ports on the Console side of the Local Unit (CE-220L).

3.Plug the appropriate connectors on the KVM cable supplied with this unit into the CPU side of the CE-220L. Each connector is marked with an appropriate icon to indicate which it is.

Note: The female monitor connector is the one that plugs into the CE-220L.

4.Plug the connectors on the other end of the cable into the appropriate ports on the computer (or Console section of the KVM switch if you are using one). Each connector is marked with an appropriate icon to indicate which it is.

5.Plug either end of the Category 5 twisted pair cable into the CE-220L's Remote I/O port.

6.Slide the Range Switch to the Long position if the Remote Unit’s location is more than 30m away; slide it to the Short position if the Remote Unit’s location is less than 30m away.

7.Plug one of the power adapters (supplied with this package) into an AC source; plug the adapter's power cable into the CE-220L's Power Jack

8.Plug the other end of the Category 5 twisted pair cable into the I/O port of the Remote Unit (CE-220R).

9.Plug the cables from the remote console devices (mouse, keyboard, monitor), into their ports on the Console side of the CE-220R.

- 7 -