Atlantic Technology instruction manual SB-800 Subwoofer Rear Panel

3

Instruction Manual

SB-800 Subwoofer Rear Panel

Figure 1

11

10

12

	4	3			5	2	1	8	7
LOW-PASS		STANDBY		PHASE		STATUS	LEVEL	INPUT	OUTPUT
	140	ON	AUTO
80	160
									L / MONO
55	200			0	180		MIN MAX
									RIGHT
	LOW-PASS		BYPASS

ON

SERIAL SB800BJRWWY80100

OFF MODEL SB-800-BLK Powered Subwoofer

		WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK.
		DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.
220-240V	110-120V	CAUTION
		DO NOT OPEN
		RISK OF ELECTRIC SHOCK

AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR

	FOR CONTINUED PROTECTION AGAINST RISK OF FIRE,
	REPLACE ONLY WITH SAME TYPE AND RATING OF FUSE
AC INPUT	DOUBLE INSULATION - WHEN SERVICING,
	USE ONLY IDENTICAL REPLACEMENT PARTS
50-60Hz
110W MAX

6

9

FOR 110-120VAC, USE T1.0AL 250V FUSE

FOR 220-240VAC, USE T1.6AL 250V FUSE

1 Bass Level Control 7 Low Level Output

Use this control to set the level of bass desired

2Status LED

This will be green for "on" condition, amber for "standby"

3Standby Switch

When in ON position,the amplifier will always be on.When in the AUTO position, the amplifier will be in Automatic Standby Mode.

4Low-Pass Control

An adjustable (55Hz to 200Hz) @ 18dB per octave low-pass crossover.

5Phase Switch

This switch allows precise acoustic matching with satellite speaker systems whose output may be phase reversed. Try in both posi- tions — use the position that results in the strongest bass output.

6Low-Pass Switch

When in the LOW-PASS position, adjustment of the crossover can be made by the Crossover Control.If being fed a pre-filtered or THX signal, place the switch at the BYPASS position.

The outputs allow daisy chaining of multiple subwoofers, or as a return path back to the processor.

8Low Level Input

Use the input to connect to the subwoofer or LFE line out from your processor/receiver.

9Product Serial Number

Write this number in the space provided on page 2 for future reference.

10Voltage Select Switch

Voltage switch for use in different countries.This switch will be set when you receive the unit. Change this setting only when you are sure your application requires it. For US, the switch should be set to the 115V position.

11On/Off Switch

Use this switch to turn the amplifier completely on or off.

12AC Input

Use the included power cord to connect your amplifier to a wall outlet.