Atlantic Technology instruction manual SB-900Subwoofer Rear Panel, your processor/receiver

3

Instruction Manual

SB-900 Subwoofer Rear Panel

Figure 1

1 2 3 4 5 6 7

12

PHASE
INVERT	NORMAL		LEVEL		LOWPASS
						80			RIGHT
	AUTO								LOW LEVEL
OFF		ON
STATUS			MIN	MAX	40	220	BYPASS		L / MONO
		OUTPUT					INPUT		HIGH LEVEL
RIGHT			L / MONO			RIGHT		L / MONO

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK.		AC INPUT
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE.	50-60 HZ 180W MAX

			CAUTION	110-120V
			RISK OF ELECTRIC SHOCK
			DO NOT OPEN
	AVIS: RISQUE DE CHOC ELECTRIQUE-NE PAS OUVRIR
FOR CONTINUED PROTECTION AGAINST RISK OF FIRE,
REPLACE ONLY WITH SAME TYPE AND RATING OF FUSE
		DOUBLE INSULATION - WHEN SERVICING,
		USE ONLY IDENTICAL REPLACEMENT PARTS		220-240V

SERIAL	SB900BJRWWY80100	FOR 110-120V, USE T2AL 250V FUSE
		FOR 220-240V, USE T1AL 250V FUSE
MODEL SB-900-BLK Powered Subwoofer		ENGINEERED IN THE USA,
		MANUFACTURED IN CHINA

8

9

10

11

1	Status LED	7 Low Level Input
	This will be green for "on" condition, red for "standby"	Use the input to connect to the subwoofer or LFE line out from
2	Standby Switch	your processor/receiver.

When in ON position,the amplifier will always be on.When in the AUTO position, the amplifier will be in Automatic Standby Mode.

3Phase Switch

8High Level Output

Connect main Left/Right speakers here when using the High Level Input.

This switch allows precise acoustic matching with satellite speaker systems whose output may be phase reversed. Try in both the highest and lowest positions — use the position that results in the strongest bass output.

4Bass Level Control

Use this control to set the level of bass desired

5Low-Pass Control

An adjustable (55Hz to 200Hz) @ 18dB per octave low-pass crossover.

6Low-Pass Switch

When in the LOW-PASS position, adjustment of the crossover can be made by the Crossover Control.If being fed a pre-filtered or THX signal, place the switch at the BYPASS position.

9High Level Input

If your electronics do not have a line-level sub out,connect the Left- Right speaker terminals of your electronics to these connections. Set the SB-900’s crossover to“Lowpass,” and adjust accordingly.

10AC Input

Use the included power cord to connect your amplifier to a wall outlet.

11Voltage Select Switch

Voltage switch for use in different countries.This switch will be set when you receive the unit. Change this setting only when you are sure your application requires it. For US, the switch should be set to the 115V position.

12Product Serial Number

Write this number in the space provided on page 2 for future reference.

SB-900 Manual.indd 3

10/18/10 3:19:35 PM