
ENGLISH
•Virtual Circuit: Enable
•VPI: 0 or 1 (check with your ISP)
•VCI: 38 or 50 (check with your ISP)
•NAT: Enable
•Username: Enter the username provided by your ISP(case sensitive).
•Password: Enter the password provided by your ISP (case sensitive).
•Service Name: This item is for identification purposes. If it is required, your ISP will provide you the information.
•IP Adress:0.0.0.0
•Authentication Protocol Type: Default is Chap (Auto). Your ISP will advise you whether to use Chap or Pap.
•Connection: Chose Always On If you want the router to establish a PPPoE/A session when starting up and to automatically
•Idel Timeout:
•RIP: No Rip
•MTU: 1492 (PPPoE), 1500(PPPoA)
Press Apply and then click on Save Config to Flash.
Now You can check on the section Status if connection is up and You can begin navigation. For every other problem refer to Manual or Multimedia Guide on attached
You have to pay particular attention to the
35