Mounting Accessories

A Tile Bridge is included in the package for suspended ceiling applica- tions. The light weight design of the FAP40T coupled with the "Dog Leg" mounting system allows the FAP40T to mount into most drywall ceilings without the need for a separate mounting ring.

For new construction drywall ceiling applications, the optional FA-TR4 trim ring is available. This unit provides a marked location for drywall installers to cut around, essentially reserving the desired location in the ceiling until final installation of FAP40T. Mounting holes are provided to accommodate 16" or 24" OC stud / joist mounting.

The package includes an attractive press-fit grille, which nicely matches contemporary architecture.

The FAP40T includes a secondary support point built into the termination cover. This "ring" may be used with an auxiliary support cable in drop tile installations.

FAP40T

(Shown Installed in Drop Tile Ceiling)

FAP40T

(Dog Ears Open on Included Tile Bridge)

Architect & Engineer Specifications

The loudspeaker system shall be Atlas Sound FAP40T. System shall include a high performance 4" loudspeaker, ported bass reflex enclosure and press-fit grille for conventional ceiling installation.

Frequency response for the system shall be 100Hz – 12kHz (±3dB), 80Hz – 15kHz (±5dB). Sensitivity shall be 87dB average.

Loudspeaker shall be compromised of a 4" cone type driver. Cone shall be constructed of polypropylene with a butyl rubber surround. Magnet shall be a minimum of 13oz (368.5g) and the voice coil diameter shall be 1" (25mm).

Transformer shall be a 70.7V / 100V type with 1, 2, 4, 8, and 16 watt primary taps (@70.7V) with a front mounted tap selector switch. This tap selector switch shall also include a transformer bypass setting for instances where the 8Ω FAP40T driver is to be direct coupled with a low impedance amplifier.

Enclosure shall be an injection molded plastic design. Internal volume shall be 85 in3 (1.4L).

To facilitate connection in conduit systems, enclosure shall be equipped with an access panel covering a recessed terminal cup. This cover shall provide a 7⁄8" (22mm inside diameter) hole for top access.

External wiring shall be accomplished via a two pole terminal strip with screw-down terminals to provide secure wire termination.

The system shall include a tile bridge assembly to reinforce the ceil- ing material. The tile bridge shall be designed for use on either 2' x 4' (609mm x 1219mm) or 2' x 2' (609mm x 609mm) suspended ceiling tiles.

Overall front face diameter shall not exceed 73⁄8" (187mm); overall height shall not exceed 71⁄8" (181mm).

Grilles shall be press-fit, manufactured from 24-gauge perforated steel mesh and finished in white epoxy. Round grille shall be 51⁄2" (140mm) diameter.

The loudspeaker shall be the Atlas Sound FAP40T.

1601 JACK MCKAY BLVD. ENNIS, TEXAS 75119 U.S.A. TELEPHONE: (800) 876-3333

FAX (800) 765-3435

Atlas Sound FAP40T specifications Mounting Accessories, Architect & Engineer Specifications

Models: FAP40T