Atlas Sound FAP82T specifications Front Mounted Tap Selector C-Ring / V-Rails

©2008 Atlas Sound L.P. All rights reserved. Atlas Sound and Strategy Series are trademarks of Atlas Sound L.P. All other trademarks are property of their respective owners. ATS001619 RevB 10/08

Architect & Engineers Specifications	connector with screw-down terminals to provide both secure wire ter-
	mination and pre-wiring capability before loudspeaker installation. The 4
System shall include a high performance 8" coaxial loudspeaker, ported	pole locking connector shall be located in the recessed area behind the
bass reflex enclosure and press-fit grille for conventional ceiling installa-	conduit access panel.
tion. Frequency response for the system shall be 65Hz – 20kHz (±5dB).	A 1⁄4"–20 drop forged eyebolt factory installed into an insert on top of
Sensitivity shall be 90dB average.
	enclosure for additional suspension point when used in drop tile ceilings
Loudspeaker shall be comprised of an 8" coaxial cone type driver. Cone	or for pendant mounting.
shall be constructed of polypropylene with a butyl rubber surround. The	Construction of enclosure shall be a minimum of 18-gauge deep drawn
19mm tweeter shall be constructed of PEI. Woofer magnet shall
	metal finished in white epoxy.
be a minimum of 21oz (595g) and the voice coil diameter shall be 11⁄2"
(38mm).	The system shall include a support backing plate to reinforce the ceil-
Transformer shall be a 70.7V / 100V type with primary taps at 1.9, 3.8,	ing material and tile support rails for use on either 2' x 4' (609mm x
	1219mm) or 2' x 2' (609mm x 6 9mm) suspended ceiling tiles. This
7.5, 15, 30, and 60 watts (@ 70.7V) with a front mounted tap selector
	assembly can all be installed from beneath the ceiling tile.
switch. This tap selector switch shall also include a transformer bypass
setting for instances where the 8Ω FAP82T driver is to be direct coupled	Overall front face diameter shall not exceed 153⁄4" (400mm); overall height
with a low impedance amplifier.	shall not exceed 111⁄ " (292 mm), 123⁄4" (324mm) including factory-installed
Enclosure shall be a deep drawn steel enclosure design. Internal volume	eyebolt.
shall be 937 in3. To facilitate connection in conduit systems, enclosure	Grilles shall be press-fit, manufactured from 24-gauge perforated steel
shall be equipped with an access panel covering a recessed terminal cup.	mesh and finished in white epoxy. Round grille shall be 13.67" (347mm)
This cover shall provide a combination in 3⁄4" (19mm inside diameter) / 1"	diameter.
(25mm inside diameter) knock-out on the side access and top access	The loudspeaker shall be the Atlas Sound FAP82T.

compression fitting / strain relief to facilitate flexible(preliminary)conduit up to 22mm outside diameter or 1" (25mm inside diameter) conduit when the com-

pression fitting is removed.

External wiring shall be accomplished via a removable lockable wiring

Front Mounted

Tap Selector

C-Ring / V-Rails

1601 JACK MCKAY BLVD. ENNIS, TEXAS 75119 U.S.A. TELEPHONE: (800) 876-3333

FAX (800) 765-3435

AtlasSound.com 3/5