RS-232
Connection
5
4 
3 
2 
1
9 
8 
7 
6
Baud Rate: 9600bps
Command
|
| No. | Pin |
| Function |
|
|
| 1 |
| Not used |
| |
|
| 2 | Tx |
| Transmit |
|
|
| 3 | Rx |
| Receive |
|
|
| 4 |
| Not used |
| |
|
| 5 | Gnd |
| Ground |
|
|
| 6 |
| Not used |
| |
|
| 7 |
| Not used |
| |
|
| 8 |
| Not used |
| |
|
| 9 |
| Not used |
| |
|
|
|
|
|
|
|
Data Bit: 8bits | Parity: None | Stop Bit: 1bit |
| |||
The command codes are very sensitive, do not change capitalization, spacing, or lettering.
| Command | Feedback | Description |
|
| PWON | PWON | Power on |
|
| PWOFF | PWOFF | Power off |
|
| All# | All# | Resets all inputs to corresponding outputs (in3 to out3) |
|
| x1$ | x1$ | Turns off output channel (to turn off output 3 = x3$) |
|
| x1AVx2 | x1AVx2 | Switch input to output (input 3 to output 5 = x3AVx5) |
|
| x1AVx2,x3,x4 | x1AVx2,x3,x4 | Switch input to multiple outputs (input 3 = x3AVx1,x2) |
|
| Statusx1 | x7AVx1 | Shows what input is connected to selected output |
|
| Status | x1AVx1, x2AVx2, | Displays which inputs are currently connected to which outputs |
|
|
| x3AVx4, .... |
|
|
| Save[Y] | Save2 | Saves settings for future use, saves vary from 0 to 9 |
|
| Recall[Y] | Recall2 | Pulls up saved settings for the number you selected |
|
| Clear[Y] | Clear2 | Erases the save for the number you selected |
|
| Mreset | Mreset | Sets matrix back to the default settings |
|
|
|
|
|
|
Each command or feedback is terminated with a carriage return.
Note: If the command fails or is incorrect the feedback should be “Command FAILED”
Toll free: | 5 | atlona.com |
Local: |
