INTRODUCTION
This home theater wall plate is Designed primarily for High Definition Multimedia Interface(HDMI) connection
Note: The wall plate terminals will accomodate only standard HDMI connectors (HDMI Type A)
APPLICATIONS
A great product for custom applications. If you want to hide your wires in the walls, it would be really hard to not use a wall plate. This wall plate features 24k gold plated HDMI receptacles. This wall plate supports any HDMI type connectors. Compatible with any single gang box. 4 inch wire on the rear of the wall plate will allow you to easily connect cable run- ning in the wall to the wall plate without bending it.
SPECIFICATIONS
Max. Resolution | 1080p |
Wall Plate type | Single Gang |
HDMI Compatability Ver. | 1.3a |
HDMI Inputs | 1 |
HDMI Outputs | 1 |
Extension Cables | |
|
|
INSTALLATION
You can mount this speaker wall plate using a standard single electrical box.
1.Route the cable through the opening in the back of the electrical box.
2.Rear connector is attached to a short extension cable to prevent wallplate and HDMI cable damage.
3.Remove the Face plate from the wall plate by pushing down on HDMI connector with your thumbs and at the same time pulling two opposite corners away. Under the face plate you will find two screws hidden there. Place the wall plate against the opening of the electrical box, then thread the two supplied screws through the screw holes in the wall plate and the electrical box, then tighten the screws and reattach the face plate.
Rear HDMI |
| Front HDMI | ||
Connector |
|
|
| |
|
|
| Connector | |
| ||||
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
Toll free: | 2 | www.atlona.com |
Local: |
