ATN Biocular manual Operation

OPERATION

•Take the biocular out of the case.

•Install the batteries into the housing with the polarity order as shown on the biocular. Battery Type: 3-Volt Lithium, #CR123A.

•Press the button marked -/O to turn the unit on with the protective lens covers still attached to the lenses. Do not turn the unit on in the daytime without the protective lens caps on. You should see a green glow in the eyepiece.

•Observe the scene and adjust the diopters for the optimal image clarity.

•You may now enter the dark environment or simply shut the lights off in order to darken the room.

•Next, remove the lens caps/daylight filters and observe the scene. You should readjust the diopters for maximum clarity. Remember, the focus range of the biocular is 20’ to infinity.

•The unit will turn on and off automatically when you bring it to or take away from your eyes. This is done by activating the proximity sensor. To activate the proximity sensor push the digital control marked “A”. You will notice the green LED change to red when the sensor is

on.

•In order to assure the proper functioning of the proximity sensor make sure that the protective glass surface of the sensor is always clean.

•Adjust the digital features as needed.

•Take your time to learn about your “smart “ biocular. It will take practice to properly use the device. As you use these biocular you are able to improve your speed of focusing, as well as sharpness of the image.

•Have fun and enjoy.

Power button

Infra-red illumina- tor ON/OFF switch

Proximity Sensor

ON/OFF switch

3V lithium battery

90mm F 1.2 lens for maximum clarity

6